Step 1

Pat the pork belly dry as much as possible with a paper towel, then remove the skin with a sharp knife, leaving as much of the fat on it as possible (unless you want to remove some of the fat).

Step 2

Cut the pork into 1-inch wide strips, and then cut each strip into pieces about ¾-inch thick. (The pork will shrink after frying so the final pieces will be smaller).

Step 3

Place the pork into a large mixing bowl and add the fish sauce, sugar, and white pepper. Use your hand to massage the pork and mix all the seasonings. Keep massaging for a minute or so until you no longer feel the grains of sugar, and there is no more fish sauce pooling at the bottom of the bowl.

Step 4

In a small bowl, combine the all-purpose flour and the cornstarch and mix well. Sprinkle the flour mixture over the pork and mix well, making sure none of the pieces are sticking together. You want a light and even coating on all the pieces. Let it sit for 5 mins or so while you heat up the oil.

Step 5

Add at least 1 inch of frying oil to a wok or a medium pot and heat it to 350°F (175°C) for the first fry.

Step 6

First Fry: Add half of the pork, placing it in the hot oil one piece at a time to ensure they are not sticking together. Fry for 2 minutes (time this). Maintain the heat of the oil between 300-350°F during the frying; on my electric stove I keep it on medium high, but it will vary from stove to stove.

Step 7

Remove the pork promptly and place on a plate to cool until it’s no more than lukewarm before frying them a second time. Repeat with the second batch, being sure to bring the oil temp back up to 350°F before frying.

Step 8

Second Fry: Once the pork is cool, bring the oil temp up to 385°F(196°C) over high heat. Add the pork all at once and fry for 70-90 seconds, or until the exterior is a deep golden brown. You can fry them for a maximum of 2 minutes; beyond this the pork will become too dry. Remove and place on a paper towel-lined plate to drain. Be sure to bring the temp back up to 385°F before frying the second batch.

Step 9

Allow the pork to cool for a few minutes before digging in as the fatty part of the pork is VERY hot out of the fryer!!