Step 1

Remove the head shell to dispatch the lobster. You can discard these, or trim them so that they can sit upright on the plate (if you want to keep them for presentation, which is what's done in most restaurants).

Step 2

Cut off the mouth portion of the lobster head with a cleaver or chef's knife. Cut or twist off the lobster claws, and cut off the smaller legs. Set those aside.

Step 3

Remove and discard the lobster gills, which are inedible. Remove the green mustard, innards and the sand tract. Rinse all the lobster pieces under cold running water. You can discard the mustard, use it in another dish, or include it in this dish. We left it out (some people don't like the strong flavor).

Step 4

Split the lobster lengthwise from the head portion to the end of the tail, so you have two halves. Take each half and cut off the upper section, separating it from the tail portion (there's actually quite a bit of meat in that piece). Cut each tail half into 3 equal pieces, giving you 6 total tail meat pieces. You can adjust this according to the size of the lobster.

Step 5

Separate the elbow joint from the claws and split each claw with a cleaver (using a mallet may help).

Step 6

Let all of the lobster pieces drain of excess water after you rinse them and pat dry with a paper towel.

Step 7

Mix the flour and cornstarch in a shallow bowl, and lightly dredge the lobster pieces. Dredge only the exposed meat to seal in the juices.

Step 8

At this point, many restaurants deep fry the lobster in a large wok to quickly seal in the juices. This process only takes 20 seconds or so, but for home cooking, we'll use a smaller pot and fry in batches. This flash fry method cooks the lobster about 70% of the way through, enhances the lobster flavor, produces a rich color, and seals in the juices while preventing the tender meat from overcooking.

Step 9

Heat 2 cups of oil in a small pot to about 350 degrees F, and drop the lobster into the pot a couple pieces at a time for about 10 seconds. Remove to a sheet pan to drain. The shells should turn bright red almost instantly.

Step 10

To finish the dish, start with a clean wok over high heat. Add 2 tablespoons oil to the wok, along with the ginger. Let the ginger fry for about 30 seconds, until fragrant.

Step 11

Add the white portions of the scallions and the lobster. Stir fry on for 20 seconds, keeping the heat cranked up as high as it'll go.

Step 12

Pour the wine around the perimeter of the wok and immediately cover it. Let it cook for about 2 minutes. This step infuses or "bakes" the lobster with the ginger and scallion flavor.

Step 13

Uncover the wok and add the soy sauce, sesame oil, sugar, white pepper, and the rest of the scallions. Stir fry for another minute. You can add a couple tablespoons of water if the wok is too dry. Serve!