Homemade Bread (Homemade White Bread)

Step 1

Place the water in the mixer bowl of your stand mixer.

Step 2

Stir in the honey to dissolve, and sprinkle the yeast over the water. Gently stir to mix.

Step 3

Allow the yeast to sit in a warm place for about 15 minutes, until it's activated and becomes frothy. This could take longer if your yeast was in the freezer. If the yeast doesn't activate (no frothy bubbles), then your yeast is likely too old and you will need it replaced with fresh yeast.

Step 4

Once the yeast is activated, you’re ready to make the bread dough.

Step 5

To the proofed yeast mixture, add the flour, warm water, salt, honey, citric acid and melted butter.

Step 6

Using a dough whisk or a spatula, mix the ingredients to form a rough dough.

Step 7

Place the bowl in the mixer with a kneading hook attached, and knead the dough on low speed for about 2 - 5 minutes, until the dough comes together to form a ball.

Step 8

Increase the speed by 1 or 2 levels (speed 3 or 4 in a kitchen aid mixer) and knead the dough for a further 12 - 15 minutes until it's smooth and elastic.

Step 9

While the dough is kneading, check on it every few minutes to make sure it’s kneading well, and is not too dry or too wet. The dough is going to be very sticky and wet at the beginning, and become smoother as it's kneaded.

Step 10

To check if the dough has the right consistency after about 10 minutes of kneading - Increase the speed of the mixer to about 5 or 6 just for a minute or two. If the dough is sticking to the sides of the bowl, then it’s too wet, so add a little extra flour (a dusting at a time), to get the right texture. If the dough is still tacky but is coming off the sides (mostly), and only sticking to the bottom of the bowl, then it's at the right consistency. When you stop the mixer and lift the kneading hook from the bowl, and the dough isn’t sticking to the bottom of the bowl, then the dough might be too dry. You may need to add a little extra water (just ½ tsp at a time), to get the right consistency. The dough should be smooth, a little soft and tacky to the touch.

Step 11

Once the dough is kneaded, remove the dough hook and fold the dough over a few times by hand, to get a smooth ball. Then place it in a lightly oiled bowl, and cover with plastic wrap. Let the dough proof for about 1 hour until it has at least doubled in size.

Step 12

While the dough is proofing, prepare the bread loaf pans. Butter 1 - 9 x 5 inch loaf pan for a very large loaf, or 2 - 8.5 x 4.5 inch loaf pans for smaller loaves, and set aside until the dough is ready.

Step 13

Turn the proofed dough out onto a lightly floured work surface. Slightly flatten is with your hands. If making two smaller loaves, halve the dough with a sharp knife or bench scraper. (For more accurately halved dough, weigh the dough and then split it evenly by weight.) Place one portion of the dough back in the bowl and place it in the fridge while you shape the first portion.

Step 14

Gently press the dough into an evenly thick rectangle. The short side of this rectangle should be roughly about 8 - 8.5 inches (i.e. slightly shorter than the length of your bread loaf pan).

Step 15

Next, tightly roll up the short side, along the length of the dough rectangle. Make sure to pinch / press the edge of the dough as you go, while rolling it up (read the post and see pictures for more details).

Step 16

Once the dough is rolled up, pinch the seams to seal it, and tuck in the two sides and pinch these seams as well. Make sure all the seams are on one side (this will be the bottom) and the other side is smooth and seam-free (this will be the top).

Step 17

Transfer this into the prepared loaf pan, seam side down, and press the dough into the pan. Make sure it’s evenly pressed into the bottom of the pan. Loosely cover the loaf pan with plastic wrap and let it proof again in a warm place, for about 45 minutes - 1 hour. The dough should double in size inside the loaf pan / pans.

Step 18

Repeat with the second portion of dough (if making two smaller loaves).

Step 19

To check if it has proofed enough, gently press the top of the dough with your finger to leave an indentation that is about ½ cm deep. If proofed properly, this indentation should remain, or only bounce back slightly. If it bounces back almost completely, then it's underproofed. (Read the post and see pictures for more details.)

Step 20

Preheat the oven (conventional oven) to 375°F / 190°C, during the last 30 minutes of the second proofing time. It’s best for the oven to be preheated to the right temperature for at least 20 minutes before baking the bread.

Step 21

When the bread loaf is ready and the oven has preheated, place the loaf pans in the middle of the oven, and bake for 35 - 45 minutes. Make sure there is at least 2 inches of space between the pans to allow for proper air circulation. The bread is done when it sounds hollow when tapped on top, OR when the internal temperature reaches 195°F / 91°C.

Step 22

Remove the pans from the oven and keep in a warm place (away from drafts) to cool. After about 10 minutes, remove the bread from the pans and keep it on a wire rack to cool down completely. The bread is now ready to be served.

Step 23

Optional - brush melted butter on top while it's hot to add more buttery flavor.

Step 24

Keep the loaf (or loaves) in a bread box at room temperature for up to 4 - 5 days, or slice and keep in the freezer for up to 1 month.