How to Make a Duct Tape Wallet

Step 1

Cut 4 pieces of tape, about 10" long, and lay them on the work surface, sticky side up.

Step 2

Connect them all together by sticking the top of the second one, to the bottom of the first one, then connect the third to the second and the fourth to the third.

Step 3

Cut another piece, the same length, and press it sticky side to sticky side, against the bottom strip of tape. Continue with 3 more strips until you have a solid sheet made of tape. Use scissors to trim the ends.

Step 4

Fold the sheet in half to resemble a wallet shape.

Step 5

Fold it in half the other way to create a bi-fold wallet. If it's too large for your liking, you can trim more off the ends now. Don't trim too much, you will need room for credit card slots.

Step 6

Cut a long strip of tape, about 18 inches long, and place it, sticky side up, on the work surface.

Step 7

Cut another piece, the same length as the first, and tape it, sticky side down, onto the other piece (sticky to sticky).

Step 8

Cut another 18" length and tear it in half lengthwise. Set aside one half and use the other half to create a smooth top seam on your long strip of tape.

Step 9

Use the second half strip to do the other side. Trim the ends.

Step 10

Using a credit card or gift card as a measuring guide, Cut the length of tape into "credit card pockets", leaving about 1/4" on each side of the card.

Step 11

Set the card aside and use the first one that you cut to use as a guide and cut three more, for a total of four.

Step 12

Cut a piece of tape a little bit longer than the length of your wallet. Tear the strip in half and create smooth seams on both sides by taping one side, then flipping it over and folding the tape over to the other side.

Step 13

With the tape sheet folded in half like a wallet, place the four credit card pockets in place.

Step 14

Cut a piece of tape about 4" long and tear it in half lengthwise. Press the tape up the center, covering the pockets. Fold the end of the tape over only one layer, you don't want to tape your money pocket shut! Tuck it inside the wallet.

Step 15

Use similar sized pieces to cover the outer edges of the pockets, folding over to secure.

Step 16

Use scissors to trim the ends.

Step 17

Put a strip of tape across the bottom to secure the pockets.

Step 18

Important: You will want to make sure that the back part of the wallet is slightly higher than the front so that when it is folded shut, it will look right.

Step 19

Make sure you have taped all your edges. If necessary, use scissors to snip any closed tape at the edges of the paper-money pocket.

Step 20

That's it! You just made a wallet completely out of duct tape (or Duck tape, whichever you chose to use)!