How to use a Kreg Jig

Step 1

Measure the open doorway.

Step 2

Cut lumber to create a rectangle frame just under the doorway measurements. Be sure measurements clear your doormat.

Step 3

If using a Kreg Jig, drill pocket holes into the 2 side boards.

Step 4

Attach side boards to top and bottom boards using pocket hole screws.

Step 5

Prop frame up against your front door to decide where you wish for added elements and supports that will compliment your front door.

Step 6

Add a center horizontal board in the middle of the door frame for support. Drill pocket holes into this piece and attach to frame.

Step 7

Attach a heavier center support to the lower half of the door.

Step 8

Insert additional vertical supports to the lower half of the door for looks and durability.

Step 9

Lightly sand the frame.

Step 10

Stain all the wood with 2 coats for added durability.

Step 11

Lay the screen door front-side-down.

Step 12

Cut 1 piece of screen slightly larger than the entire door frame opening.

Step 13

Staple screen into place with an electric staple gun.

Step 14

Cut cedar strips to fit over top of the staples to hide them. Screw them into place once stained.

Step 15

Decide where the door hinges will be placed. I added a 1x2 to one side of the doorway for this to work on mine.

Step 16

Attach the hinges to the door and 1x2.

Step 17

Add remaining hardware such as door pull or anything else desired.

Step 18

Install 4 corner supports on an angle out of cedar strips to keep door squared-up.