Step 1

Trim any excess hard pieces of fat from the exterior of the brisket, leaving about 1/4 inch thickness on the fat cap.

Step 2

Score the fat cap to allow more fat to render out and the rub to penetrate.

Step 3

Mix the Marinade Injection ingredients well until the sugar dissolves.

Step 4

Place the brisket in a pan to catch excess liquid from the injections and inject in small amounts every 1 inch or so on both sides against the grain of the meat.

Step 5

Apply a thin layer of cooking oil to the entire exterior of the brisket.

Step 6

Mix the rub ingredients well and apply generously to the entire exterior.

Step 7

Wrap in plastic wrap and place in the refrigerator for up to 2-3 hours while you prepare the grill to allow the injection and the exterior rub to penetrate the meat.

Step 8

Remove the fire pot from the bottom of the Pit Boss and clean out any ashes left over from the last cook. Replace it and make sure it is secured in place with the clips on either side. Also, wrap the drip tray in aluminum foil to limit cleanup needed later.

Step 9

Add your chosen pellets to the hopper, start the Pit Boss pellet grill and put it on the "Smoke" setting.

Step 10

If there are no pellets in the auger, hold the "Prime" button until you hear pellets begin falling in the fire pot. This will speed up the auger to prime it full of pellets before you start preheating.

Step 11

Once the Pit boss begins to produce thick white smoke, let it run for about 5-7 minutes until the smoke turns more of a clearish blue color. This means the fire rod has fully heated up to burn the pellets more cleanly.

Step 12

Next, set the temperature to preheat the Pit Boss pellet grill to 350°F. We will drop this temperature before we start cooking.

Step 13

Fill an aluminum pan with water pan if you want to add extra moisture, and place it on the far left side of the Pit Boss pellet grill. Place a disposable bucket liner in the grease bucket as well if you want to limit cleanup later.

Step 14

Once the Pit Boss has come up to 350°F, drop the temperature on the control panel to 250° and clean the grill grates with a good grill brush and close the lid.

Step 15

Remove the plastic wrap and place the brisket on the Pit Boss with the thicker end pointing to the right.

Step 16

Place an internal temperature probe if you have one into the center of the brisket.

Step 17

Close the lid, cook the brisket until it reaches about 150-160°F internally.

Step 18

At this point you can leave the brisket on the Pit Boss to continue cooking or remove it and wrap it in foil to speed up the cooking time.

Step 19

Carefully remove the brisket and place on a large sheet of aluminum foil.

Step 20

Wrap the brisket in opposing directions with three layers of foil, tightly.

Step 21

Replace the temperature probe and place back on the Pit Boss.

Step 22

When the internal temperature of the brisket has reached 200°F, remove from the Pit Boss and keep wrapped.

Step 23

Let the brisket rest for at least 60 minutes before slicing to allow the juices to distribute.

Step 24

After resting, place the brisket on a large cutting board. Slice against the grain on a diagonal in ¼ inch slices and serve immediately.

Step 25

Save extra brisket unsliced and tightly wrapped to maintain moisture.