The Best Cold Process Soap Recipe

Step 1

Using a digital scale, measure out the lye and water in separate glass containers.  Combine them by adding the lye to the water.  (Remember: snow floats on the lake.). Stir until the lye dissolves.  The temperature will shoot up.  Place this in a safe place to cool.

Step 2

While the lye solution is cooling, measure out the oils and butters and combine them in a large stainless pot.  Melt them over low heat and heat them up to 130-140 degrees.  Set them aside to cool.

Step 3

After 2 hours, check the temperature of both solutions.  They should be around 110 degrees.  (A range of 100-120 is fine.). If not, allow them to cool longer.

Step 4

Prepare your mold and measure out any fragrance or color you will be adding.  (For best blending of colors, mix some color into a few drops of melted oils.). If using sodium lactate, add it to the lye water at this time.

Step 5

Pour the water and lye solution into the pot with the melted oils.  Blend with a stick blender until thin trace is reached.  The soap batter will noticeable thicken and a trail of soap will sit on top of the liquid rather than immediately sinking in.  (This will take about 1 minute.). Add the color and fragrance and stir by hand.

Step 6

mmediately pour the soap batter into the mold.  Place in a turned off oven or wrap with blankets to insulate the soap.

Step 7

After 24 hours of curing, unmold and cut into bars.  The bars may seem slightly soft but will harden considerably during the curing process. Allow to cure at least 3 weeks in a well-ventilated place.