Wood Burn with Ammonium Chloride

Step 1

Cut stencil by hand or use a Cricut. Tip: use a good qualty vinyl

Step 2

Apply stencil to wood and seal with several light coats of clear coat. Let dry overnight.

Step 3

Mix together ammonium chloride, warm water and add 1/4 tsp of thicken up or Xanthan gum.Tip: Blend with an immersion blender or in a Magic Bullet - just a few pulses until gel consistency.

Step 4

Peel stencil and brush solution onto the bare wood. Let dry.

Step 5

Set heat gun to high. Tip: Use short bursts and hold the heat gun a good distance away.Keep the gun moving until desired effect is achieved.