DIY Angle Base Dining Table

Step 1

Cut List 1

Step 2

Cut List2

Step 3

Cut List 3

Step 4

Cut the planks to size and drill 1 1/2" pocket holes on one edge of 7 of the boards and both ends of all of the boards. Attach the planks together with 2 1/2" pocket hole screws.

Step 5

Measure and cut the breadboards to size. Attach thm to the ends of the planks with 2 1/2" pocket hole screws and wood glue.

Step 6

Cut the leg pieces to size and attach them together with 2 1/2" finish nails and wood glue. Build 4 leg assemblies.

Step 7

Cut the top piece to size and attach the legs to the top base with 3" wood screws from the top of the top base and into each leg. Use wood glue. Build 2 bases.

Step 8

Flip the base over and cut the first bottom base piece to size and attach it to the legs the same way.

Step 9

Cut the second bottom base piece to size and attach it to the first bottom base piece with 2 1/2" wood screws and wood glue.

Step 10

Cut the foot pad pieces to size and attach them to the bottom of the base with 1 1/4" brad nails and wood glue.

Step 11

Cut the middle cross pieces to size, drill 1 1/2" pocket holes according to the cut list and attach them with 2 1/2" finish nails as shown below. Note the location of the pocket holes. Build 2 of each.

Step 12

Attach the 2 shorter cross pieces to the long cross piece with 2 1/2" pocket hole screws and wood glue. Build 2 of these.

Step 13

Slide the cross in between the 2 legs. Attach each corner to the legs with 2 1/2" and 3 1/2" wood screws and wood glue.

Step 14

Cut the top corner pieces to size and attach them together with 2 1/2" finish nails and wood glue. Build 4 corner assemblies.

Step 15

Attach the corner pieces to the top corners of the bases with 2 1/2" wood screws and wood glue into the legs and top of the base.

Step 16

Cut the runners to size and drill 1 1/2" pocket holes at both ends. Attach the runners to the ends of the top of the bases with 2 1/2" pocket hole screws and wood glue.

Step 17

Cut the bottom runner to size and drill 1 1/2" pocket holes at both ends. Attach the runners to the ends of the top of the bases with 2 1/2" pocket hole screws and wood glue.

Step 18

Put the table base on top of the table top and attach the base to the top with 2 1/2" wood screws from the bottom of the runners and top base pieces and into the planks.

Step 19

That's it! Fill any exposed nail and screw holes, sand it down and add a finish! Make sure to share your builds with us on social media and use #shanty2chic so we can share them too!