Step 1

A lot of beef cuts come with a fat cap. Trim the fat off and cut the meat into manageable pieces that will be easy to slice. Then put the meat in a plastic bag and put in a freezer for a few hours. Freezing will firm it up and make it a easy to slice evenly.

Step 2

When the meat is firm, slice it about 3/16" - 1/4" thick. Thinner sliced meat tends to come out dryer and less chewy. Thicker will take a long time to dry.

Step 3

To make the jerky chewy, slice it along the grain.

Step 4

To make the jerky less chewy, slice it across the grain.

Step 5

Combine all the ingredients for the marinade in a large Ziploc bag and shake.

Step 6

Add the meat slices, shake and massage the meat really well.

Step 7

Refrigerate for 24 to 48 hours, flipping the bag and massaging the meat every 6-8 hours. Strictly speaking, marination is not necessary, but it makes jerky much more flavorful inside out and tenderizes tougher beef cuts.

Step 8

Remove one rack from the oven so you can start hanging the meat slices on it. Meanwhile, preheat oven to 300F.

Step 9

Hang the meat on the oven rack. The most efficient way is to hang the meat slices vertically, as shown on the picture below. This way you can have about 5 lbs of meat on one rack, properly spaced out.

Step 10

Once the oven is preheated to 300F, bring the meat in, close the oven door, turn the temperature down to 275F and bake the meat for 10 minutes. This will bring its internal temperature to the safe level of 160F.

Step 11

Drop the temperature further to the lowest setting your oven can go, e.g. 170F. Crack open the oven door and insert a thick wooden spoon to secure it in that position.

Step 12

After about 30 minutes, when the temperature in the oven has stabilized at its lowest setting, turn on the convection fan, if you oven has it. It will expedite the drying process. You will have to find a creative way to keep the button down to activate convection.

Step 13

Continue drying jerky until it's ready. The jerky is dry enough when it bends without breaking, while surface develops cracks when you bend it. This will take anywhere from 4 to 8 hours, depending on whether you use convection and the thickness of meat slices.