Step 1

Before You Start…Please note that this recipe requires 2+ hours of chilling time.

Step 2

One batch of the custard mixture makes a little less than 3 cups (720 ml), which can fill five 220-ml molds, six 150-ml molds, or seven 120-ml (4-oz) molds. If your molds are larger, use fewer of them for this recipe.

Step 3

Gather all the ingredients. Preheat the oven to 300ºF (150ºC). For a convection oven, reduce the cooking temperature by 25ºF (15ºC). Start boiling about 3–4 cups hot water of water in a kettle (or medium pot) and keep it hot. We‘ll use this hot water later for the caramel and bain-marie.

Step 4

In a heavy-bottomed small saucepan, combine 70 g sugar (about 5 Tbsp) and 1 Tbsp water at room temperature. Avoid a nonstick pot because it‘s too thin and the inner pot color makes it hard to see the caramel color. Turn on the heat to medium low and let the sugar dissolve completely, without stirring. You can tilt the pot occasionally, but otherwise don‘t touch it until the sugar turns liquid.

Step 5

When the sugar has dissolved, increase the heat to medium to medium high. Swirl the saucepan once in a while to mix the mixture, but do not use a utensil because it will cause the sugar to crystallize. Tip: This sauce will take about 5 minutes to make, so have the hot water ready to use at that time.

Step 6

When the sugar starts to caramelize, you will see lots of small bubbles. It will slowly turn brown on the edges of the pan. Swirl the pot to incorporate the dark-colored caramelized sugar into the light-colored sugar. Soon, the bubbles will become larger as the sugar mixture caramelizes more and turns an amber color.

Step 7

The caramelized sugar will continue to turn darker and darker. Keep swirling the pot and watch it closely. After the caramel sauce starts smoking, wait a tiny bit longer until it reaches an optimal dark caramel color. Then, turn off the heat. Tip: I like my caramel sauce to have a dark brown color with a bittersweet taste to balance out the custard‘s sweetness.

Step 8

Immediately pour a little bit of the 1 Tbsp hot water onto a spatula into the caramel pot (so your hand is not directly above the pot). The mixture will boil vigorously and sputter, so be careful not to let it splatter on you. Once this has subsided, slowly add the rest of the hot water. Swirl the saucepan to combine.

Step 9

As soon as the hot caramel sauce is done—and before it quickly cools and hardens—pour it directly from the pot into the molds. Divide the sauce equally among the molds and aim for a thin caramel layer of ⅛ inch (3 mm) or so. Set them aside. Don’t worry if your caramel hardens before it coats the entire surface. When you add the hot milk mixture later, the caramel will melt a bit and the moisture from the caramel will eventually coat the bottom of the mold. Tip: One batch of sauce is enough to cover the bottom of five 220-ml molds or six 150-ml molds. You may want to add less caramel sauce if your mold’s base is narrow, or more sauce if it’s wide (such as 120-ml/4-oz ceramic ramekins). You may have leftover sauce.

Step 10

Tip: Do you have some caramel stuck to the pot? Add milk and heat up while stirring. My kids enjoy caramel milk.

Step 11

Combine 400 ml whole milk (1⅔ cups), 100 ml heavy (whipping) cream (6 Tbsp plus 2 tsp), and ½ tsp pure vanilla extract (or the vanilla bean seeds and pod) in a small saucepan.

Step 12

Whisk it all together. Turn on the heat to medium low and bring the milk mixture to just a simmer.

Step 13

Meanwhile, crack 3 large eggs (50 g each w/o shell) into a large bowl and beat with a whisk until smooth.

Step 14

Add 70 g sugar (about 5 Tbsp) to the eggs and mix until everything is combined.

Step 15

When small bubbles start to appear around the edges of the saucepan, turn off the heat.

Step 16

While whisking continuously, slowly add one-third of the hot milk mixture into the egg mixture. Then, continue to add the rest of the milk mixture slowly, again whisking continuously. Mix it all together. Tip: Add the hot milk mixture slowly to keep the eggs from curdling.

Step 17

Set a fine-mesh sieve over another bowl or liquid measuring cup with a spout. Then, strain the custard mixture through the sieve to remove any lumps.

Step 18

Evenly divide the custard mixture among the molds with a ladle (or pour it using the measuring cup with spout).

Step 19

Make sure all of your molds have an equal volume of custard so the cooking time will be the same.

Step 20

Burn off the bubbles on the surface of the custard using a long-stemmed utility lighter (candle lighter) by quickly touching them with the flame. You could also pop them with a toothpick or scoop them off with a spoon, but those are both time-consuming methods. Compare the surface of the custard in the previous step with the surface after burning off the bubbles in the image on the right.

Step 21

Place the molds in a baking dish, roasting pan, or rimmed oven-safe container (I use an enamel bake pan) that's at least 2 inches (2.5 cm) deep so you can add hot water to it. Then, put the dish or pan on a baking sheet. This way, you won‘t burn your hands with the hot water as you transfer the pan to the oven. Now, make a bain-marie (hot water bath): Add hot water to the pan halfway up the sides of the molds. Tip: If the water temperature is not hot enough or you pour in too little hot water, the pudding will not set and it will take longer to cook.

Step 22

Place the baking dish or pan in the preheated oven. Bake the pudding at 300ºF (150ºC) for 35–45 minutes, or until the custard is set. Then, remove from the oven. How do you know it‘s cooked? See the next step. Tip: The baking time varies depending on the size and material of the molds. If you use larger and thicker molds than mine (like ceramic ramekins), they will need to cook for 45–60 minutes. It took 55 minutes for my seven 120-ml/4-oz ceramic ramekins.

Step 23

Check for doneness by tilting the molds. It‘s done cooking if the surface of the pudding is slightly wobbly and jiggles, but is no longer liquid and does not move.

Step 24

Take out the molds from the water bath (I use a hot plate retriever). Let cool completely on a wire rack.

Step 25

Once cooled, cover the molds with plastic or aluminum foil and refrigerate for 2–3 hours.

Step 26

Instead of baking in the oven, you can cook the custard in a pot on the stovetop. First, wrap the pot‘s lid with a tea towel to prevent condensation from dripping onto the custard. Next, fill the large pot with enough water to reach about halfway up the sides of the molds when you put them in later. Then, start boiling the water. Tip: Make sure there is no excess cloth hanging off the lid, which could catch on fire over the flame.

Step 27

Once the water is boiling, turn the heat to low and gently place the molds into the pot. Cover tightly with the lid and simmer gently for 10 minutes. Tip: When you cook on low heat, you will minimize any rattling sounds from the molds moving on the bottom of the pot.

Step 28

Then, without opening the lid, turn off the heat. Use the remaining heat in the covered pot to continue cooking the pudding for another 10 minutes. Then, check for doneness by tilting the molds. If the custard doesn't move, it‘s done. If the custard looks slightly liquid and loose, cook for an additional 5 minutes. Let cool completely on a wire rack. Once cooled, cover the molds with plastic or aluminum foil and refrigerate for 2–3 hours.

Step 29

Place the molds in a hot steamer, leaving the lid slightly ajar to let the hot steam escape. Steam on low heat for 15–20 minutes or until cooked through. Check for doneness by tilting the molds. If the custard doesn't move, it's done. Let cool completely on a wire rack. Once cooled, cover the molds with plastic or aluminum foil and refrigerate for 2–3 hours. Tip: It's not easy to control the temperature with this cooking method. If you‘re new to making Purin, I highly recommend cooking it in the oven or in a bain-marie in a pot on the stove.

Step 30

Run a butter knife or offset spatula around the edge of the molds. Alternatively, use a spoon or finger to gently push down the edge of the purin. Place a serving plate face down on top of a mold.

Step 31

Flip to release the purin and caramel sauce from its mold and onto the plate. If it doesn‘t unmold, shake it once to see if that helps. If not, try one more time, but this time a bit vigorously. Carefully remove the mold. Repeat with the other molds.

Step 32

You can also serve it in a small bowl.

Step 33

Keep the purin in their molds and store in the refrigerator for up to 3–4 days. Remove from the mold right before serving. I recommend consuming it sooner than later for the best taste.