Step 1

Put the rice in a sieve(with holes small enough so the rice doesn't pass through) over a bowl and wash the rice with cold tap water.

Step 2

Use your hands to remove the excess starch off each grain of rice by using a gentle rubbing motion. If you scrub too hard you will break the rice, so don't be too rough.

Step 3

When the water that runs off is mostly clear, drain the rice.

Step 4

If you're using a rice cooker, add the rice to the bowl of the rice cooker and add cold water to just under the 2 cup line (you want the rice to be on the firm side as you'll be adding the seasoned vinegar after the rice is cooked). If you don't have a rice cooker, add the rice to a large heavy bottomed non-stick pot, then add 1 1/2 cups of cold water.

Step 5

Ideally you want to let the rice sit in the water for at least 30 minutes before you start cooking it. This allows the grains of rice to soak up some water before cooking, which results in shinier rice with a better texture.

Step 6

If you are using a rice cooker, turn it on and let it do it's thing. If you are doing this on the stove, turn the heat onto high and bring the rice to a boil (be careful not to let it boil over). Turn down the heat to low and cover with a lid. Set a timer for 15 minutes. Once the rice is done, turn off the heat and let the rice steam for 10 minutes.

Step 7

While you wait for the rice to cook, combine the vinegar, sugar and salt in a small bowl. You can microwave it for a bit to help dissolve the sugar.

Step 8

After the rice has had a chance to steam, it should be firm, but the core should not be crunchy. It should be sticky, but each grain of rice should retain its own shape. If your rice was fresh, the surface of each grain should be glossy.

Step 9

Dump the rice out into a very large bowl, the key is that you want a container with a lot of surface area so you can spread the rice out to cool it rapidly. Gently flatten out the rice and then pour the vinegar mixture evenly over the hot rice.

Step 10

Use a shamoji, spatula or a flat wooden spoon to gently combine the rice and vinegar using a side-to-side cutting motion followed by a folding motion. You want to separate each grain of rice, so the vinegar penetrates every surface, but you don't want to break the grains of rice or mash them together.

Step 11

While you mix the rice, hold a fan or piece of cardboard, or a clean hairdryer set to cool and blow air on the rice. This cools the sushi rice and helps the excess liquid evaporate quickly, which gives your rice a nice shine and prevents it from getting mushy. It's a bit tricky mixing and fanning at the same time, so a second set of hands can be helpful here.

Step 12

The sushi rice is done when the surface is no longer wet and slippery, the rice is fluffy, and each grain is very shiny. It will still be a little warm, but it should not be hot.

Step 13

Mound up the rice, and cover with a damp towel until you're ready to use it.